Pre version 8.3 to statically NAT an internal host to an external IP address you would use the following:
This then means...... inside = the source interface for the NAT connection (assuming going from the inside to the outside) outside = the translated interface for the NAT connection 212.219.63.195 = External IP address to which the internal host is translated to on the outside. 192.168.100.10 = Internal IP address from which is the original source of the traffic. network mask 255.255.255.255 = Specfies that it is a single host, change this to 255.255.255.0 for a range of addresses for example. |
Cisco and Networking >