The Ramblings of a Computer Geek
I had a bit of a read about that issue you were talking about with the fire suppression system causing system outages for Channel 4 recently (article). The reports all used seem to use the phrase “sucked the air out of the room”, this would imply a vacuum, which it wouldn’t have been. So in […]
More...
The Synology NAS range can be used to run the Plex Media Server. However the Plex service needs to be configured with permissions to read your media files. In my example I have a Shared Folder on the NAS called “tv”, and I want Plex to be able to read, index and play these files. […]
More...
The 5520-VIM-4YE, this has 4 x SFP28 ports 10/25. You can use 10Gbit or 25Gbit speeds on these ports. On an Extreme 5520 Universal hardware switch this will be ports 57-60 (on 48port model) or 33-36 (on a 24 port model) If you want to use 4 x SFP+ modules running at 10Gbit, you need […]
More...
Emails crossing the internet use secure connections encrypted using Transport Layer Security (TLS). However, there remain vulnerabilities in this method of protecting the confidentiality of emails, whereby a person-in-the-middle can trick incoming connections to send to another server and/or send information in the clear. MTA-STS is a standard designed to address these vulnerabilities and is […]
More...
The Kemp Load Master allows for the configuration of authentication offloading to itself (from the Microsoft Exchange server supporting Kerberos) to allow for the Kemp Load Master to act as a sP (Service Provider) against an IdP (Identity Provider) for example OKTA. The use of SAML via OKTA allows for any SAML (and Kerberos KCD […]
More...
The Extreme Networks X695 switches have a special port configuration arrangement that you need to be aware of when configuring the switch for use. Verified on: ExtremeXOS version 30.6.1.11 30.6.1.11-patch1-4 by release-manager on Tue Jul 7 10:36:05 EDT 2020 The switch supports the following: 48 x SFP28 1Gb/10Gb/25Gb Ports 8 x QSFP28 40Gb/100Gb Ports Up […]
More...It is pretty standard practice to disable the default VLAN and renumber its tag ID for security reasons, from version 22.4 and above we often go this issue when performing these basic commands: We’d get the error as below. In our case we don’t want to run STP (Spanning Tree Protocol) because we’re using either […]
More...
It is helpful to monitor the RxErrors and TxErrors on ports on Extreme Networks switches to get a heads up on any issues before they begin to impact service. The Extreme Networks MIB can be downloaded from the Extreme Networks support portal to assist you in finding the relevant SNMP OIDs, the below is an […]
More...
Microsoft have published a vulnerability: https://msrc.microsoft.com/update-guide/vulnerability/ADV210003 which allows an attacker to use the NTLM authentications to begin an attack chain to make an unauthenticated NTLM connection that is then relayed to allow a connection to the Active Directory Certificate Services (ADCS), this assuming the auto-enrollment is enabled means that an attacker can make a request […]
More...
A single-mode or multi-mode duplex fibre optic patch cable a simple enough item, commonly you’ll find these with an LC connector on the end. What are the types? The default type is typically a UPC (Ultra Physical Contact) type connector, if you were to ask a supplier for a fibre patch cable this is normally […]
More...